EFA:IC:4051

4051 – 8-Channel Analog Multiplexer/Demultiplexer

STILL WORKING ON THIS PAGE: COME BACK LATER.

What is a Multiplexer?

A multiplexer is a device that has multiple inputs and one output. It also has some sort of selection system that decides which of those inputs should connect to the output. The 4051 chip can be used as a multiplexer.

When used as a multiplexer, pin 3 is the output, and the 8 channels are different inputs.

What is a Demultiplexer?

A demultiplexer on the other hand is a device that has multiple outputs and only one input. The selector decides what output channel the input should connect to. The 4051 chip can also be used as a demultiplexer. Just wrap your brain to think of the inputs and outputs the opposite way.

When used as a demultiplexer, pin 3 is the input, and the 8 channels are outputs.

Selector Pins –Truth Table

The 4051 has three binary control inputs (A, B ,and C). The signals decide which channel is connected to the input/output pin. Note that the inhibit should be connected to GND (LOW) in normal use. If you make that pin HIGH, it will turn off all of the channels.

There are multiple ways to feed the control signals to the multiplexer, but one very useful way is using the 4040 chip (it is a binary counter). See the step sequencer project for detailed instructions on how to do it..